Accessories

• Designed for DJI RS 2/RSC 2 gimbal.
• Comes with cold shoes, 1/4”-20, and ARRI 3/8”-16 accessory mounts.
• Horizontal Adjustable & Upside Down Holding.
• Dual NATO rails, quick release, and attachment when shooting in inverted mode.
• Anti-removal stud to secure the accessory from falling by accident.
• Matte surface perfectly matches with the industrial design of the stabilizer.

• Design for DJI RS 2/ RSC 2 & Ronin-S and ZHIYUN gimbals.
• Balance front-heavy cameras on the gimbal.
• Clamps onto the rear of the Manfrotto camera plate with thumbscrew.
• Multiple 1/4"-20 threaded holes for adding counterweights.
• 2 x 100g counterweights Included

• Arca-Type Compatible Clamp for Gimbals.
• Quick Release the Camera using an Arca Plate Between Gimbals and Tripods.
• Install on the Gimbals Camera Plate via two 1/4” Screws.
• Degree Markings on Each Side.
• Vertical or Horizontal Installation.
• Features M4 Threaded Holes for DJI Ronin S/ Ronin SC Follow Focus Motor.

• Balance Heavy Cameras on Gimbal
• For DJI Ronin-S & Ronin-SC Gimbals
• For Zhiyun-Tech CRANE & WEEBILL LAB
• Mounts onto Gimbal Side Arm

• Shoe Mount for Accessories
• Designed for DJI Ronin-S and Ronin-SC
• Mounts with Two Captive M4 Screws
• Safety Locking Design to Prevent Slips

1. Designed for DJI Ronin S Gimbal.
2. Allows balancing of front-heavy camera setup.
3. Comes with rows of 1/4”-20 threaded holes to support counterweights.
4. Features precise scale on the side to mark camera position.
5. Compatible with the original lens support of Ronin S.
6. Comes with rubber pad to prevent scratching your camera.

1. For balancing your camera on Gimbal Stabilizers by adjusting its quantity and position.
2. Features a 1/4“-20 screw and 1/4”-20 threaded hole to support counterweight.
3. 100g Counterweight, 1.1” in diameter.

1. For balancing your camera on gimbal stabilizers by adjusting its quantity and position.
2. Features a 1/4“-20 screw and 1/4”-20 threaded hole to support counterweight.
3. 200g counterweight, 1.46” in diameter.

• Designed for DJI RS 2/RSC 2 Gimbal.
• Allows for low angle shot and reduce arm fatigue.
• Built-in 1/4”-20 threads, ARRI 3/8”-16 locating holes, and cold shoe accessory mounts.
• Tighten by ratchet knob, angle adjustable to 180°, can be used as side grip.
• Built-in NATO rail with anti-removal spring stud.
• Matte surface perfectly matches with the industrial design of the stabilizer.